![]() Our Open Port Check tool is the only online port checking tool with Guaranteed Results. To test if your port has been properly forwarded, you can use our Network Utilities tool, which includes a free Open Port Checker. Now that you have forwarded ports on the Linksys DD-WRT_v24-SP2 you should test to see if your ports are forwarded correctly. When you're finished, click Save Settings near the bottom of the screen to save your changes. Make sure that the Enabled checkbox is checked. If you are forwarding ports so you can run a program on a device other than your computer then you can enter your device's IP address into that box. If you are forwarding a range of ports, usually separated by a hyphen, then you need to enter the lowest number of that range into the Start Port box and then enter highest number into the End Port box.įrom the Protocol box select the protocol for the ports that you want to forward.Įnter the IP address to forward these ports to into the To IP Address box. If you are just forwarding a single port number then you can simply enter that same number into both the Start Port and the End Port boxes. The name does not make any difference in the forward it's just there so that you can remember later why you setup this forward. You need to name this entry in the Application Name box. Screenshot of Linksys DD-WRT_v24-SP2 port forward. It's possible for this to be either the IP address of your computer or any other IP address on your network that you want ports forwarded to. You need to enter the IP address that you are forwarding ports to in the To IP Address box. Use the Protocol dropdown box to select the protocol type of the ports you are forwarding. The name does not matter so pick something that has meaning to you.Įnter the same port number to be forwarded into both the External Port and the Internal Port boxes. Put a name for this forward in the Application Name box so that you can remember why you set this forward up.
0 Comments
Leave a Reply. |